Waldent Flexident Putty (500gm + 500gm)

• Exhibits pseudo-plastic properties for precision which is not found in alginates
• Superior tear strength than any other VPS material
• Better dimensional stability – multiple models can be poured up to two weeks
• Good hydrophilicity
• Compatible with gypsum products
• Superior wetting characteristics ensuring gypsum working cast is hard with smooth surface
• Can be subjected to cold sterilization without compromising the details and dimensional stability of the impression
• Better reproduction detail.

Waldent Flexident Putty

• Flexident Putty formulation, based on synthetic spheroidal silicas fillers, performs the maximum fluidity combined with perfect final dimensional stability.
• Flexident Putty, due to its excellent initial flowing and final rigidity, guarantees the best results for all impression techniques.
• Flexident Putty is the ideal support when employed in the “two-stage putty/wash technique” and it ensures the perfect cohesion between putty and light materials in the “single-stage double mixing technique”. This leads to the realization of high precision impressions.

Indications :

• For impressions in cases of veneers, inlay, onlay, crown or bridge
• Impressions for study models, orthodontic models, matrices

Flexident – Putty

• Working Time : 1 min 30 sec
• Setting Time : 3 min

Flexident Putty:

Dosage : Measure out level scoopfulls of Base and Catalyst.

Mixing :

1. Take the base material and the catalyst with the fingertips and start mixing.

2. Knead the material with the fingertips until the color is uniform

Recommendations for use

Double mix technique

While loading the tray, the dentist may begin to apply the washmaterial around the preparation. Tray loading and application of wash-material around the preparation have to be completed at thesame time. Keep the oral tip immersed in the material at all times to avoid trapping air. Immediately place filled tray into the patient’s mouth. Press for 2 –3 s and hold in position until the material is completely set

Two step technique

If a 2-Step «putty or heavy body /wash technique is used, the primary impression, must be carefully cleaned and dried before use. This will help guarantee good adhesion between the wash (low viscosity material) and tray material.

Disinfection :

The impression should be rinsed under (cold) running tap water after removal from the mouth. After rinsing, disinfection with a suitable commercial dental disinfectant solution will not affect the impression surface or dimensions. Acrylic trays should be protected against water absorption.